| Milliamp Source |
|
| Ranges: |
0.000 to 24.000mA; -25.00 to 125.00% of 4 to 20mA |
| Accuracy: |
±(0.05% of 24 mA Span + 0.01 mA) = 0.02mA |
| Typical Drive Capability: |
1200 Ohms @ 20.00 mA |
| Compliance Voltage: |
Nominal 25 V @ 20 mA |
| Power & Measure 2-wire Transmitters |
|
| Ranges: |
0.000 to 24.000mA; -25.00 to 125.00% of 4 to 20mA |
| Accuracy: |
±(0.05% of 24 mA Span + 0.01 mA) = 0.02mA |
| Output Current: |
Up to 24.00 mA |
| Typical Drive Capability: |
1200 Ohms @ 20.00 mA |
| Compliance Voltage: |
Nominal 25 VDC @ 20mA |
| 2-wire Transmitter Simulator |
|
| Ranges: |
1.000 to 24.000mA; -18.8 to 125.00% of 4 to 20mA |
| Accuracy: |
±(0.05% of 24 mA Span + 0.01 mA) = 0.02mA |
| Loop Voltage Limits: |
Minimum: 3 VDC
Maximum: 45 VDC |
| Overload Protection: |
Current limited to 25 mA nominal |
| Voltage Burden: |
0.9V at mA, 1.2V at 20mA, 1.9V at 24mA |
| Milliamps Read |
|
| Ranges: |
0.000 to 24.000mA; -18.8 to 125.00% of 4-20mA |
| Accuracy: |
±(0.05% of 24 mA Span + 0.01 mA) = 0.02mA |
| Overload Protection: |
Current limited to 25 mA nominal |
| Voltage Burden: |
0.9V at 4 mA, 1.2V at 20 mA, 1.4V at 24 mA |
| DC Voltage Source |
|
| Ranges: |
0.000 to 110.000mV
0.00 to 10.25V |
| Accuracy: |
±(0.05% of 110 mV+ 0.01mV) = ±0.07 mV
±(0.05% of 10.25 V + 0.01V) = ±0.02V |
| Source Current: |
>20mA |
| Sink Current: |
>20mA |
| Output Impedance: |
Greater than 0.3 Ohms |
| Short Circuit Duration: |
Infinite |
| Measure AC Volts |
|
| Ranges: |
0.0 to 250.0V True RMS |
| Accuracy: |
From 10 to 250 VAC ±(2% of 250V + 0.1 VAC) = ±5.1VAC |
| Maximum Crest Factor: |
Greater than 3 |
| Frequency Range: |
45 to 800 Hz |
| General |
|
| Typical 90 day Accuracy: |
±(0.025% of Full Scale + 1 LSD) |
| 1 Year Accuracy: |
±(0.05% of Full Scale + 1 LSD) |
| Warm up Time: |
10 Seconds to specified accuracy, 2 minutes to maximum accuracy |
| Temperature Effect: |
±0.01%/°C based on 23°C ±25°C |
| Batteries: |
Six "AA" (R6) batteries (Alkaline supplied and recommended) |
| Battery Life: |
Milliamp Source and 2-wire Modes: Nominal 50 hours at 12 mA, 20 hours at 20 mA with 250 ohm load
Other Functions: Nominal 50 hours |
| Low Battery Indication: |
"BAT" indication on the display, approximately 4 hours left |
| Overload Protection: |
Three fuses, 250 mA |
| Noise: |
=1 LSD at frequencies less than 10 Hz |
| Normal Mode Rejection Ratio: |
50dB @ 50/60 Hz |
| Operating Temperature Range: |
-5 to +130 °F (-20 to +55°C) |
| Storage Temperature Range: |
-13 to +130 °F (-25 to +55°C) |
| Relative Humidity: |
10 to 90%, non-condensing for 24 hours |
| Dimensions: |
158.1mm (6.23 in) x 83.1mm (3.27 in) x 49.3mm (1.94 in) |
| Weight: |
1lb 5oz (0.6kg) |
